Dkduino Pro Mini 328 - 5V/16Mhz
Details
The Dkduino Pro MIni 328 is a clone of the well known Sparkfun Arduino Pro Mini 328 with the same features. Very high quality Clone by DK
This is a 5V Arduino running the 16MHz bootloader (select 'Arduino Duemilanove w/ 328' within the Arduino software). The Dkduino Pro Mini does not come with connectors populated so that you can solder in any connector or wire with any orientation you need. The Arduino Pro series is meant for users that understand the limitations of system voltage (5V), lack of connectors, and USB off board.
The Dkduino Pro Mini is like the Arduino Mini (same pin out) but to keep the cost low, we used all SMD components, made it two layer, etc. This board connects directly to the FTDI Basic Breakout board and supports auto-reset. The Arduino Pro Mini also works with the FTDI cable but the FTDI cable does not bring out the DTR pin so the auto-reset feature will not work.There is a voltage regulator on board so it can accept voltage up to 12VDC. If you're supplying unregulated power to the board, be sure to connect to the "RAW" pin on not VCC.
Features:
- ATmega328 running at 16MHz with external resonator (0.5% tolerance)
- USB connection off board
- Supports auto-reset
- 5V regulator
- Max 150mA output
- Over current protected
- Reverse polarity protected
- DC input 5V up to 12V
- On board Power and Status LEDs
Dimensions:
- 0.7x1.3" (18x33mm)
- Less than 2 grams
Powered by Magento extensions
Wählen Sie die Artikel aus, die dem Warenkorb hinzugefügt werden sollen oder Alle wählen
Es ist kein Artikel zum Vergleichen vorhanden.
Sie haben keine Artikel im Warenkorb.
