Tinkerforge Bricks
Bricks are 4 x 4cm (1.57 x 1.57") boards equipped with a preprogrammed 32-bit ARM microcontroller, a Mini-USB port, two status LEDs, connectors for stacking and up to four connectors for Bricklets. There are Bricks that perform complex sensor tasks (e.g. IMU Brick), communicate (e.g. Master Brick) and drive motors (e.g. DC Brick).
Bricks can be assembled into a stack. A Master Brick at the bottom of a stack is responsible for the communication all boards within the stack. This master routes the messages between the boards in the stack and the PC. For the user, the stack behaves as if all Bricks were connected separately over USB with the PC.
-
Tinkerforge Debug Brick
The Debug Brick can be used to add JTAG and serial console debug capabilities to Bricks, Bricklets and stacks. Learn More -
Tinkerforge HAT Brick
Raspberry Pi HAT with standard HAT form factor with eight ports for Bricklets Learn More -
Tinkerforge HAT Zero Brick
Raspberry Pi HAT with Raspberry Pi Zero form factor and four ports for Bricklets Learn More -
Tinkerforge IMU Brick 2.0
Full fledged IMU/AHRS with 9 degrees of freedom (3-axis each: accelerometer, compass, gyroscope) No accumulating errors, no gimbal lock! Learn More -
Tinkerforge RED Brick
The Rapid Embedded Development Brick (RED Brick) can control other Bricks and Bricklets. Learn More -
Tinkerforge Silent Stepper Brick
Drives one bipolar stepper motor over USB (max. 46V, 1.6A per phase) Learn More -
Tinkerforge Stepper Brick
Drives one bipolar stepper motor with max. 38V and 2.5A per phase - Position, velocity and acceleration controllable Learn More
Minimal Price: 18.90