Search results for 'pin'
-
6 x 10mm LED-Breakout with Enable-Input - Set
Set with 6 Breakout-board with 10mm LED (Red) and enable input Learn More -
Play-Zone Breakout Board for XBee Module
This board breaks out all 20 pins of the XBee to a 0.1" standard spacing dual row header. Learn More -
DK 16-Channel 12-bit PWM/Servo Driver - I2C interface - PCA9685
Erhalten Sie mit nur 2 Pins 16 unabhängige PWM-Ausgänge. Verbinden Sie bis zu 62 dieser Breakouts und erhalten Sie 992 PWM Ausgänge!
Learn More -
DK 16-Channel 12-bit PWM/Servo Shield - I2C interface
Using only two I2C pins, control 16 free-running PWM outputs! You can even stack up 62 shields to control up to 992 PWM outputs Learn More -
NeoPixel Digital RGB LED Strip 144 LED 2M Black PCB - WS2812
We crammed ALL THE NEOPIXELS into this strip! An unbelievable 144 individually-controllable LED pixels on a flexible PCB. 2 Meters which Black PCB! Learn More.Regular Price: CHF119.90
Special Price CHF109.90
Currently out of stock
-
9DOF IMU with ADXL345, HMC5883L and ITG3205
9 Degrees of Freedom on one small board! Learn More -
LinkSprite Voltage Translator Shield für pcDuino V2 / V3
3.3V <-> 5V Level Translator Shield für den pcDuino V2 / V3 Learn More.Regular Price: CHF17.90
Special Price CHF7.90
Currently out of stock
-
GY Digitaler Ambient Light Sensor mit BH1750FVI
Messen Sie die Umgebungslichtstärke von 1 - 65535 Lux via I2C Learn More -
Adafruit 2.8" TFT LCD with Touchscreen + MicroSD Socket
2.8" TFT LCD with Touchscreen Breakout Board w/MicroSD Socket Learn More -
Adafruit NeoPixel 1/4 60 Ring - WS2812 5050 RGB LED
The biggest NeoPixel Ring yet! With four of these you can make a huge ring with 60 ultra bright smart LED NeoPixels are arranged in a circle with a 6.2" diameter. Learn More -
Adafruit MCP9808 High Accuracy I2C Temperature Sensor
This I2C digital temperature sensor is one of the more accurate/precise we've ever seen, with a typical accuracy of ±0.25°C over the sensor's -40°C to +125°C range Learn More -
Adafruit Music Maker MP3 Shield for Arduino (MP3/Ogg/WAV...)
This powerful shield features the VS1053, an encoding/decoding (codec) chip that can decode a wide variety of audio formats such as MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM). It can also be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. Learn More -
JST SH Jumper 6 Wire Assembly - 8"
JST SH Jumper 6 Cable for GPS Receiver - GP-635T Learn More -
Rotary-Potentiometer B10K
Standard 3-Pin Potentiometer / Trimmer 10kOhm, ROHS Learn More -
Rotary-Potentiometer B10K with Knob
Standard 3-Pin Potentiometer / Trimmer 10kOhm, ROHS Learn More -
Rotary-Potentiometer B100K with Knob
Standard 3-Pin Potentiometer / Trimmer 100kOhm, ROHS Learn More -
SparkFun T5403 Barometric Sensor Breakout
This is the T5403 breakout board, a fully calibrated barometric pressure sensor with an I2C interface. Learn More -
SparkFun USB Type A Female Breakout
This simple board breaks out a female USB type A connector's VCC, GND, D- and D+ pins to a 0.1" pitch header. Learn More -
SparkFun Sunny Buddy - MPPT Solar Charger
Just plug your solar panel into one side of the Sunny Buddy and your battery into the other and you are good to start charging! Learn More -
Atmel ATMEGA328P-AU - TQFP
ATMega 328 TQFP-Package. Without Arduino Bootloader! Learn More -
Adafruit NeoPixel Ring - 12 x WS2812 5050 RGB LED
Round and round and round they go! 12 ultra bright smart LED NeoPixels are arranged in a circle with 1.5" (37mm) outer diameter. Learn More -
TI 74AHCT125 - Quad Level Shifter 3V/5V
Level shifting chips let you connect 3V and 5V devices together safely. Learn More -
Play-Zone Proto One V1.0 - Kit
Experimentierplatine und Arduino in einem? Kein Problem mit dem neuen Proto One von Play-Zone Learn More -
TinyCircuits TinyShield USB & ICP
The TinyShield USB & ICP add USB support for the TinyDuino via a micro-USB connector and uses the very popular FTDI USB to Serial converter IC (as used on most standard Arduino models). Learn More -
TinyCircuits TinyShield 16 Edge LEDs - Green
Sixteen green LEDs around the Edge of the Board Learn More -
TinyCircuits TinyShield 16 Edge LEDs - Red
Sixteen red LEDs around the Edge of the Board Learn More -
Optical Dust Sensor - Sharp GP2Y10
Sharp’s GP2Y1010AU0F is an optical air quality sensor, designed to sense dust particles. Learn More -
SparkFun MiniGen - Pro Mini Signal Generator Shield
A small shield for the Arduino Pro Mini that is capable of generating sine, square, or triangle waves at up to 3MHz Learn More -
NeoPixel Diffused 8mm Through-Hole LED - 5 Pack
Each LED looks just like your classic through-hole 8mm RGB LED with 4 legs, but instead of just red/green/blue there's a little chip inside that can control the LED with high speed PWM for 24-bit color. Learn More -
Solenoid / Hubmagnet 5V
his smaller solenoid is designed to work directly with 5V which makes it a great match for embedded projects. Learn More
